gibson:teaching:spring-2016:math445:lecture:timestepping
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
gibson:teaching:spring-2016:math445:lecture:timestepping [2016/04/14 11:55] gibson [Problem 3] |
gibson:teaching:spring-2016:math445:lecture:timestepping [2016/04/14 18:23] (current) gibson [Problem 4] |
||
|---|---|---|---|
| Line 81: | Line 81: | ||
| {{ :gibson:teaching:spring-2016:math445:lecture:cylinderpath1.png?direct&400 }} | {{ :gibson:teaching:spring-2016:math445:lecture:cylinderpath1.png?direct&400 }} | ||
| - | Note that the computed trajectory is not very accurate, since we chose quite a large time step $\Delta t = 0.4$, and forward-Euler is only 1st-order accurate (error scales as $\Delta t$). | + | |
| + | Note that the trajectory computed here is not very accurate. The particle shouldexit the box at the same $y$ value it had when it entered. The problem is we chose quite a large time step $\Delta t = 0.4$, and forward-Euler is only 1st-order accurate (error scales as $\Delta t$). In the next problem, we'll reduce the time step to $\Delta t = 0.01$ and get a more accurate solution --though still not as good as the 4th-order accurate ''ode45'' function. | ||
| ---- | ---- | ||
| ====Problem 2==== | ====Problem 2==== | ||
| - | Write Matlab code that plots the //path// of the particle as a red curved line. To do this wee need to save the sequence of $\vec{x}$ values in a matrix, and then plot the rows of that matrix as a line. | + | Write Matlab code that plots the //path// of the particle as a red curved line. To do this we need to save the sequence of $\vec{x}$ values in a matrix, and then plot the rows of that matrix as a line. |
| <code matlab> | <code matlab> | ||
| Line 127: | Line 129: | ||
| axis equal | axis equal | ||
| axis tight | axis tight | ||
| - | xlim([-xmax,xmax]) | + | xlim([-3,3]) |
| - | ylim([-ymax,ymax]) | + | ylim([-2,2]) |
| </code> | </code> | ||
| Line 170: | Line 172: | ||
| x0 = [-2.8; y]; % set initial position of particle | x0 = [-2.8; y]; % set initial position of particle | ||
| - | [t, x] = ode45(@v, [0 T], x0); % compute x(t) at given values of t | + | [t, x] = ode45(@v, [0 T], x0); % compute x(t) over range 0 <= t <= T |
| plot(x(:,1), x(:,2), 'r-'); % plot the path | plot(x(:,1), x(:,2), 'r-'); % plot the path | ||
gibson/teaching/spring-2016/math445/lecture/timestepping.1460660158.txt.gz · Last modified: 2016/04/14 11:55 by gibson
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 3.0 Unported
