installation:segmentation_fault_while_running_some_test_cases
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
installation:segmentation_fault_while_running_some_test_cases [2011/06/22 12:29] pg_chaos |
installation:segmentation_fault_while_running_some_test_cases [2011/06/22 13:02] pg_chaos |
||
|---|---|---|---|
| Line 9: | Line 9: | ||
| ~~DISCUSSION~~ | ~~DISCUSSION~~ | ||
| - | I have installed the latest version of ChannelFlow on my account on a intel linux cluster, running Centos 5.2 with 2.6 kernel. | + | I have installed the latest version of ChannelFlow on my account on a intel linux cluster, running Centos 5.2 with 2.6 kernel and gcc 4.1.2 |
| I had to play around with FFTW-3.2.2 library a bit (i.e. use -fPIC flag while building FFTW) before I could (semi)-successfully build ChannelFlow. I haven't downloaded/installed Octave yet. | I had to play around with FFTW-3.2.2 library a bit (i.e. use -fPIC flag while building FFTW) before I could (semi)-successfully build ChannelFlow. I haven't downloaded/installed Octave yet. | ||
| - | So I ran the ./configure command and then did a make. It runs for a while, and then exits with an error message saying | + | So I ran the ./configure command and then did a make. The make process runs for a while, and then exits with an error message saying |
| "No rule to make target `dnsLaminarTest.o', needed by `dnsLaminarTest'. Stop. " | "No rule to make target `dnsLaminarTest.o', needed by `dnsLaminarTest'. Stop. " | ||
installation/segmentation_fault_while_running_some_test_cases.txt ยท Last modified: 2011/06/22 13:03 by pg_chaos
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 3.0 Unported
