This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
installation:segmentation_fault_while_running_some_test_cases [2011/06/22 12:29] pg_chaos |
installation:segmentation_fault_while_running_some_test_cases [2011/06/22 12:30] pg_chaos |
||
---|---|---|---|
Line 12: | Line 12: | ||
I had to play around with FFTW-3.2.2 library a bit (i.e. use -fPIC flag while building FFTW) before I could (semi)-successfully build ChannelFlow. I haven't downloaded/installed Octave yet. | I had to play around with FFTW-3.2.2 library a bit (i.e. use -fPIC flag while building FFTW) before I could (semi)-successfully build ChannelFlow. I haven't downloaded/installed Octave yet. | ||
- | So I ran the ./configure command and then did a make. The runs for a while, and then exits with an error message saying | + | So I ran the ./configure command and then did a make. The make process runs for a while, and then exits with an error message saying |
"No rule to make target `dnsLaminarTest.o', needed by `dnsLaminarTest'. Stop. " | "No rule to make target `dnsLaminarTest.o', needed by `dnsLaminarTest'. Stop. " | ||